Creative Quilling Forum

Stopping your strips walking.....

View previous topic View next topic Go down

Stopping your strips walking.....

Post by admin on 2010-10-23, 00:56

When husking, place your pins on a slight angle away from your strips so that it sits against your board better without going walkies up your pin. This will help stop an uneven result on your project. Don't angle it too much or your loop will loop will be affected just a little and this will save you lots of aggravation. Also using a shorter pin makes life easier.
Karon

_________________
Life is not measured by the breaths we take but by the moments that take our breath away. George Carlin
avatar
admin
Admin

Posts : 714
Join date : 2010-01-07
Location : Australia

Back to top Go down

Re: Stopping your strips walking.....

Post by Heather on 2010-10-23, 02:26

Thank you for this tip. I haven't done much in the way of husking but I will remember this tip for when I do get adventurous.
avatar
Heather

Posts : 327
Join date : 2010-07-17
Location : Canada

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum